Vehicle-Specific Installation Notes

Rain Tracker Model: RT-50
Vehicle-Specific Installation Instructions
The instructions included with the product tell you how to install a Rain Tracker. This page gives special vehicle-specific information. Print this page using your browser's print function.

Application Vehicles
These instructions apply to these vehicles, which all have similar wiper systems:

PLYMOUTH PROWLER 97 - 01

Wiring Diagrams and Drawings:

2000 Plymouth Prowler- Drawing applies to all application vehicles listed above. Print this.
RT-50 - HSS (Hot Side Switching)- Included with product, so print only if needed.
Troubleshooting procedure- Print out if needed.

Wire colors used in this vehicle:

+12V - DK-BLU/LT-GRN
GROUND - CHASSIS
FAST - RED/BLK
SLOW - BRN/WHT

Special Rain Tracker Installation Notes for this vehicle:

Write the wire colors of the vehicle on the HSS drawing, and follow that
when you wire up the Rain Tracker. Use the factory drawing as a reference
to help you find the wires. Some models and years may vary slightly in wire colors.
Factory drawings can be wrong, so, confirm wire colors with a multimeter.

All wiper system wires, except ground, are available at the wiper switch. They
can usually be accessed by removing one or two access panels (Kick Panels) and,
possibly, the shrouds surrounding the steering column.

FIND CHASSIS GROUND
Find a suitable screw or bolt on the metal chassis of the vehicle to use as the
Rain Tracker ground. Scrape away paint as needed for a good connection.
Use a multi-meter to verify that the ground connection is at most a few ohms.
The cigarette lighter can also be a good alternate for ground and/or power.

The Rain Tracker wiper control system works in parallel with the existing wiper system, so the existing manual control modes are not affected. This page generated by vehicle data file name: plymouth_prowler_00.veh