Vehicle-Specific Installation Notes

Rain Tracker Model: RT-50A
Vehicle-Specific Installation Instructions
The instructions included with the product tell you how to install a Rain Tracker. This page gives special vehicle-specific information. Print this page using your browser's print function.

Application Vehicles
These instructions apply to these vehicles, which all have similar wiper systems:

CHEVY-TRUCK SILVERADO 05 - 07
CHEVY-TRUCK TAHOE 05 - 06
CHEVY-TRUCK AVALANCHE 05 - 06
CHEVY-TRUCK SUBURBAN 05 - 06
GMC-TRUCK YUKON 05 - 06
CADILLAC-TRUCK ESCALADE 05 - 06

Wiring Diagrams and Drawings:

General Motors type LZ Wipers, Color Scheme 2- Drawing applies to all application vehicles listed above. Print this.
Troubleshooting procedure- Print if needed.

Wire colors used in this vehicle:

+12V - LOCATE
GROUND - TAN
FAST - DK-BLU
MUX1 - YEL
MUX2 - PNK

External Components Required for this installation

RESISTOR - 390 - Color code: ORN-WHT-BRN

Special Rain Tracker Installation Notes for this vehicle:

Use the instructions included in the Rain Tracker kit until you get to step 5a. "Make the interface
connections." At that point, use these instrctions along with the diagram that can be printed above.
Return to the general instructions when the interface connections has been completed.

Some models and years may vary slightly in wire colors. Confirm wire colors with service
guide, and/or with with a multimeter.

All wiper system wires, except +12V, are available at the wiper switch. They
can usually be accessed by removing one or two access panels (Kick Panels) and,
possibly, the shrouds surrounding the steering column.

FIND +12V
For Rain Tracker power (+12V), locate a source of power hot in accessory
or run. Power source should be min. 12-16ga. wire on a 15-25A circuit. This
can be one of the +12V sources as shown on the diagram, or some other accessory
source. The cigarette lighter is often a good +12V source.

WIRE CONNECTIONS
Check the Ground-- this can alternatively be BLK, BLK/WHT, or TAN. If you are
not sure you have a good ground, use a chassis ground.

In some, the DK BLU FAST control wire is DK-BLU/WHT directly off the switch,
and changes to DK-BLU at the connector coming from the switch wires.

The Rain Tracker wiper control system works in parallel with the existing wiper system, so the existing manual control modes are not affected. This page generated by vehicle data file name: gm_lz_c2.veh