Vehicle-Specific Installation Notes

Rain Tracker Model: RT-50A
Vehicle-Specific Installation Instructions
The instructions included with the product tell you how to install a Rain Tracker. This page gives special vehicle-specific information. Print this page using your browser's print function.

Application Vehicles
These instructions apply to these vehicles, which all have similar wiper systems:

CHRYSLER SEBRING 06 - 07
CHRYSLER TOWN & COUNTRY 92 - 95
DODGE-TRUCK CARAVAN, GRAND CARAVAN 92 - 95
PLYMOUTH VOYAGER, GRAND VOYAGER 92 - 95

Wiring Diagrams and Drawings:

1997 Dodge Ram Fullsize Van- Drawing applies to all application vehicles listed above. Print this.
RT-50A - HSS (Hot Side Switching)- Included with product, so print only if needed.
Troubleshooting procedure- Print out if needed.

Wire colors used in this vehicle:

+12V - DK-BLU
GROUND - CHASSIS
FAST - RED/YEL
SLOW - BRN/WHT

Special Rain Tracker Installation Notes for this vehicle:

Write the wire colors of the vehicle on the HSS drawing, and follow that
when you wire up the Rain Tracker. Use the factory drawing as a reference
to help you find the wires. Some models and years may vary slightly in wire colors.
Factory drawings can be wrong, so, confirm wire colors with a multimeter.

All wiper system wires, except ground, are available at the wiper switch. They
can usually be accessed by removing one or two access panels (Kick Panels) and,
possibly, the shrouds surrounding the steering column.

FIND CHASSIS GROUND
Find a suitable screw or bolt on the metal chassis of the vehicle to use as the
Rain Tracker ground. Scrape away paint as needed for a good connection.
Use a multi-meter to verify that the ground connection is at most a few ohms.
The cigarette lighter can also be a good alternate for ground and/or power.

2007 Sebring:
To install the Rain Tracker you must access the vehcile's wiper motor terminals.
This makes for a more difficult installation because the Rain Tracker wires
need to run through the firewall. If you find the diagram showing wires coming from
the wiper switch, e-mail us, at info@hydreon.com, with the diagram and we can
tell you if you can install the Rain Tracker at the switch. (The diagram we have
shows no switch so we can't tell if it can be installed there or not.)

SLOW wire connection:
Two wires come off the the switch, and come together to
a splice. (Joint connector) Make sure the Rain Tracker
installation comes is between that splice and the motor.
If the Rain Tracker is between the splice and the switch,
it will not work and you could damage the vehicle.

The Rain Tracker wiper control system is compatible a wide range of windshield transmittances and thicknesses This page generated by vehicle data file name: chrysler_vans_92-95+.veh