Rain Tracker Model: RT-40A
Vehicle-Specific Installation Instructions

The instructions included with the product tell you how to install a Rain Tracker.  This page gives special vehicle-specific information.  Print this page using your browser's print function.

Application Vehicles
     These instructions apply to these vehicles, which all have similar wiper systems:

JEEP LIBERTY 02 - 07

Wiring Diagrams and Drawings:

2004 Jeep Liberty- Drawing applies to all application vehicles listed above. Print this.
RT-40A - HSS (Hot Side Switching)- Included with product, so print only if needed.
Troubleshooting procedure- Print out if needed.

Wire colors used in this vehicle:

+12V - LOCATE
GROUND - CHASSIS
FAST - RED/YEL
SLOW - BRN/WHT

Special Rain Tracker Installation Notes for this vehicle:

Write the wire colors of the vehicle on the HSS drawing, and follow that
when you wire up the Rain Tracker.  Use the factory drawing as a reference
to help you find the wires. Some models and years may vary slightly in wire colors.
Factory drawings can be wrong, so, confirm wire colors with a multimeter.

The wiper motor wires (FAST and SLOW) are not available coming from the
wiper switch, the connections must be made at the wiper motor.

Mount the Rain Tracker control module in the passenger compartment under
inst. panel. Find suitable power and ground. Extend the FAST and SLOW
connections to the Rain Tracker through the firewall to reach the wiper motor.

FIND +12V
For Rain Tracker power (+12V), locate a source of power hot in accessory
or run. Power source should be min. 12-16ga. wire on a 15-25A circuit. This
can be one of the +12V sources as shown on the diagram, or some other accessory
source. The cigarette lighter is often a good +12V source.

FIND CHASSIS GROUND
Find a suitable screw or bolt on the metal chassis of the vehicle to use as the
Rain Tracker ground. Scrape away paint as needed for a good connection.
Use a multi-meter to verify that the ground connection is at most a few ohms.
The cigarette lighter can also be a good alternate for ground and/or power.

FAST WIRE CONNECTION
On the 05 - 07 FAST - BRN/ORN

The RT-40A does not utilize the FAST windings of the wiper motor. Please disregard any references
to FAST that appear in these instructions.

The Rain Tracker wiper control system works in parallel with the existing wiper system, so the existing manual control modes are not affected.  This page generated by vehicle data file name: jeep_liberty_04.veh

Copyright 2008 Hydreon Corporation All rights reserved.