Vehicle-Specific Installation Notes

Rain Tracker Model: RT-40A
Vehicle-Specific Installation Instructions
The instructions included with the product tell you how to install a Rain Tracker. This page gives special vehicle-specific information. Print this page using your browser's print function.

Application Vehicles
These instructions apply to these vehicles, which all have similar wiper systems:

VOLVO S60 01 - 07
VOLVO S80 99 - 06
VOLVO V70 02 - 07
VOLVO XC70 02 - 07
VOLVO XC90 03 - 07

Wiring Diagrams and Drawings:

2000 Volvo S80- Drawing applies to all application vehicles listed above. Print this.
RT-40A - HSS (Hot Side Switching)- Included with product, so print only if needed.
Troubleshooting procedure- Print if needed.

Wire colors used in this vehicle:

+12V - LOCATE
GROUND - CHASSIS
FAST - YEL
SLOW - BLU
CAM - WHT

Special Rain Tracker Installation Notes for this vehicle:

OPERATION NOTE
If you run both the Rain Tracker and the Intermittent wipers at the same time, the
wipers will sometimes stop in the middle of the windshield. This is due to the
software of the vehicle and cannot be changed. This does not introduce any safety concerns.

If you did the digital switch test and the wipers stopped in the middle of the windshield, the
RT-40A will NOT work with your vehicle. You will need to use the RT-50A.

DIGITAL SWITCH SYSTEM
These vehicles have a digital switch system and may need to utalize the CAM Feedback input
only available on the Rain Tracker model RT-50A. Check for this using the intructions below.

INSTRUCTIONS FOR DIGITAL SWITCH TEST (AT THE WIPER MOTOR)
For some digital switch systems, the software of the body control module can cause the
wipers to occaisionally stop in the middle of the windshield. The problem is that the body
control module does not run the wipers back to the home position after the Rain Tracker initiates
a wipe. You can check that the system does NOT exhibit this by:

1. Cut the SLOW wiper motor wire where you would install the Rain Tracker at the wiper motor.

2. With the vehicle on, momentarily connect the motor side to +12V, then back
to the switch side, restoring the original SLOW connection.

3. If the wipers run back home, the Rain Tracker should have no compatibility problems. But, if
they stop in the middle of the windshield, you will need to use the CAM Feedback Input located on
the RT-50A.

Mount the Rain Tracker control module in the passenger compartment under inst. panel. Find
suitable power and ground. Extend the FAST, SLOW and CAM (if needed) connections to the Rain
Tracker through the firewall to reach the wiper motor. Some models and years may vary slightly
in wire colors. Factory drawings can be wrong, so, confirm wire colors with a multimeter.

FIND +12V
For Rain Tracker power (+12V), locate a source of power hot in accessory
or run. Power source should be min. 12-16ga. wire on a 15-25A circuit. This
can be one of the +12V sources as shown on the diagram, or some other accessory
source. The cigarette lighter is often a good +12V source.

FIND CHASSIS GROUND
Find a suitable screw or bolt on the metal chassis of the vehicle to use as the
Rain Tracker ground. Scrape away paint as needed for a good connection.
Use a multi-meter to verify that the ground connection is at most a few ohms.
The cigarette lighter can also be a good alternate for ground and/or power.-

The RT-40A does not utilize the FAST windings of the wiper motor. Please disregard any references
to FAST that appear in these instructions.

Hydreon Corporation provides vehicle-specific installation information for over 5000 differen models of cars, vans, SUV's, and light trucks. This page generated by vehicle data file name: volvo_s80_00.veh